2018 Ford F150 Door Code: How to Find Your Keypad Lock Code

You want the factory-set 5-digit door code for your 2018 F-150’s keypad. This is a common issue with used trucks. The code is stored in the truck’s body control module (BCM) and on a label on the keyless entry module itself. This is a moderate job if you’re handy, but it’s tight quarters. The most common mistake: damaging trim or wiring when accessing the module.

What you'll need

• Tools
  • 7mm socket and ratchet (for trim screws)
  • Plastic trim tool (to avoid scratching panels)
  • Flashlight or phone light
• Parts & consumables
  • None, unless you break a clip or lose a screw

Step-by-step

1. Check the owner’s manual — Sometimes the code is written on a card or in the manual’s wallet. If not, move on.
2. Locate the keyless entry module — On 2018 F-150s, it’s behind the passenger side kick panel (right footwell, under the glove box).
3. Remove the passenger side kick panel — Use the trim tool to gently pry it off. Remove any screws with the 7mm socket.
4. Look for the module — It’s a black box with a white sticker. The 5-digit factory code is printed on the sticker (sometimes labeled “key code” or “entry code”).
5. Write down the code — This is your permanent factory code. Test it at the keypad before reassembling.
6. Reinstall the kick panel — Snap it back in, reinstall screws.
7. (Optional) Program your own code — Use the factory code to set a personal code (see owner’s manual for steps).

Specs & resets (verify if unsure)

• No torque specs or fluids for this job.
• To program a personal code: Enter factory code, press 1-2 within 5 seconds, enter your new 5-digit code.
• No reset procedures needed.

Common mistakes to avoid

• Breaking trim clips — Use a plastic trim tool, not a screwdriver.
• Damaging wiring — Don’t yank the panel; wires run behind it.
• Confusing the code sticker — There may be several stickers; look for the one with a 5-digit number.
• Forgetting to test the code before reassembly — Always check before putting panels back.

If you’re not comfortable pulling trim panels, a dealer or locksmith can retrieve the code with a scan tool (for a fee). No need to replace any parts unless the module is missing or damaged.

A few questions (if needed)

• Do you have both original keys? (Some methods require two keys.)
• Is the keypad physically working (lights up, buttons respond)?
• Has the truck ever had the BCM or door module replaced?
• Are you comfortable removing interior trim?
• Do you want to program a new personal code, or just need the factory one?